FAQ’S

Dlink router FAq’s

Ensure your Internet modem is connected to the WAN/Internet Port on the rear of the D-Link Router. Under the WAN/Internet Section check the following: – Cable Status- this could state Connected – If the status is Disconnected, the router isn’t detecting your modem. Please check your cabling (in step 1 above).
1. Step 1: Log into your mydlink account at http://mydlink.com. 2. Step 2: Select your router to bring up the Router Status page.
Step 1: Connect the included power adapter to a wall plug and your router. Step 2: Connect the Ethernet cable to the WAN (or internet) port of both your modem and router. Step 3: provides it a flash to start out up with a light-weight indication. Step 4: Head to your computer and your mobile device.
Step 1: Open your browser and enter the IP address of the dlink router into the address bar (not in google). The default IP is 192.168. 0.1, or using the link: http://dlinkrouter.local. Step 2: You should be taken to a D-Link router login page.
Please check the following: 1. make sure the router is during a well ventilated area. If the router doesn’t get adequate airflow, it could overheat and cause performance degradation. 2. Ensure the firmware is up to date. 3. Perform a factory reset on the router.
Press and hold the ‘reset’ button; while doing so, power on the device again and keep holding the ‘reset’ button for an additional 10 seconds. Then release the dlink router button and wait until device restarts.
Yes, WiFi routers keep logs, and WiFi owners can see what websites you opened, so your WiFi browsing history isn’t in the least hidden. … Routers keep logs to store WiFi history, WiFi providers can check these logs and see WiFi browsing history.
Deleting a router history and every one settings is extremely simple. This can be done by simply pressing the push button at rock bottom or side of the router. Usually a skinny pin or needle is required to try to to this. Every router must be equipped with a push button .
Browser History and Cache 1. Open the browser. 2. Open Internet Explorer. 3. Click the “Settings” button. 4. Log in to your router by typing 192.168. 5. Locate the administration page and look for a section named Logs. 6. Click “Enable” if the feature is not activated. 7. Access the logs by clicking “Logs” on the Logs page.
From a smartphone go to WiFi Settings and disconnect from any connections. Find the router name (SSID) and connect entering the Default WiFi password. Open a Browser and type in the default Ip Address. The Admin login page should come up type in the Default Username and Password.
Firstly the users should click on the reset button which is at the back or on the side of the router with the use of any thin object. The button should be pressed for some seconds and the users should wait till the WLAN light stops blinking. Then, open the internet browser and write “192.168. 0.1” and enter it.